Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Drain all water from the spray gun and wand by holding spray gun in a vertical
position with nozzle end pointing down and squeezing trigger. Store in gun
holder.
3.
Wrap up and secure detergent siphon hose so it is protected from damage.
DANGER: Risk of fluid injection. When using replacement spray wands or
guns with this pressure washer, DO NOT use a spray wand and/or spray gun/
wand combination that is shorter in length than what was provided with this
pressure washer as measured from the nozzle end of the wand to the gun
trigger.
NOTICE: The use of any other accessory not recommended for use with this tool
could be hazardous. Use only accessories rated equal to or greater than the rating
of the pressure washer.
Model
PSI Max*
GPM Max*
High Pressure Hose
Presure of Inlet Water
Inlet Water
Soap Consumption
Rate
* Rated Pressure and Rated Water Flow is within manufacturing tolerance of
(+/- 10%).
In a continued commitment to improve quality, the manufacturer reserves the right
to make component changes, design changes, or specification changes when
necessary and without notice.
Do not return this product to your retailer. Please contact our customer service
department at www.simpsoncleaning.com
The manufacturer of this product agrees to repair or replace designated parts that
prove defective within the warranty period listed below at the manufacturer's sole
discretion. Specific limitations/extensions and exclusions apply.
This warranty covers defects in material and workmanship and not parts failure
due to normal wear, depreciation, abuse, accidental damage, negligence, improper
use, maintenance, water quality or storage. To make a claim under the terms of
the warranty, all parts said to be defective must be retained and available for return
upon request to a designated Warranty Service Center for warranty inspection. The
judgments and decisions of the manufacturer concerning the validity of warranty
claims are final.
ACCESSORIES
SPECIFICATIONS
ALK60891
4400 PSI
4.0 gpm
50 ft. (15.24 m)
20–100 PSI
cold tap
(100 °F max)
10% max
SERVICE INFORMATION
LIMITED WARRANTY
19 - ENG
Publicidad
