HQ-Power TRIMO 310 Manual Del Usuario página 7

7.2 Menu
Refer to the illustration on page 2 of this manual.
menu description
DMX address selection.
Select menu with ENTER, select value with UP or DOWN, confirm with ENTER.
Selection of the pan and tilt direction.
Select with UP or DOWN, confirm with ENTER.
Selection of the master or slave mode.
Select with UP or DOWN, confirm with ENTER.
Backlight on or off selection.
Select with UP or DOWN, confirm with ENTER.
Sound-control on or off.
Select with UP or DOWN, confirm with ENTER.
Selection of the desired channel mode.
Select with UP or DOWN, confirm with ENTER.
Direct menu control.
Select with UP or DOWN, confirm with ENTER.
Manual control of channels 1 to 21.
Select with UP or DOWN, confirm with ENTER.
7.3 Stand-Alone Mode
In stand-alone mode, the device runs one of the built-in programs: automatic or sound-activated.
Stand-Alone Mode with Built-in Programme
To set the device to stand-alone mode:
1. Unplug any connection from the DMX input [1a] of the device.
2. Press MENU to open the menu.
3. Select <cHnL>.
4. Select one of the channel modes.
Sound Activation
With sound activation, the built-in program responds to sound. To use sound activation with the selected
built-in program:
1. Press MENU to open the menu.
2. Select <SoUN>.
3. Select <on> to enable sound activation.
7.4 Master/Slave Mode
The master/slave mode allows for connecting several devices to a single master device in a daisy chain.
All slave devices will then work synchronously with the master device. The first device in the daisy chain
functions as the master device.
To set the devices to master/slave mode:
1. Unplug any connection from the DMX input [1a] of the master device (the first device in the chain).
2. Connect the DMX input of the first slave device to the DMX output [1b] of the master device.
3. Connect the DMX input of the subsequent slave devices to the DMX output of the previous slave
device.
4. On the master device, press MENU to open the menu.
5. Select <SLnd>, then select <HoSt>.
6. For further set-up of the master device, see Stand-Alone Mode.
7. On each slave device, press MENU to open the menu.
8. Select <SLnd>, then select <SLAV>.
9. Set the DMX start address of each slave device to 1 (see DMX Mode for details).
V. 01 – 17/11/2014
VDPL310MB
7 ©Velleman nv