Publicidad
Idiomas disponibles
Idiomas disponibles
(12) AC IN SOCKET
Used to plug the power unit in.
(13) MASTER OUT
Output sockets for connecting your power amplifier.
(14) LINE / PHONO INPUT-SOCKETS
Input socket for CH-1 and CH-2. Connect your turntable with the PHONO input-sockets. CD-players or
Tape Decks should be connected with the LINE input-sockets. Line level musical instruments with stereo
outputs such as Rhythm Machines or Samplers should also be connected with the LINE input-sockets.
(15) GND (Ground terminal)
Connect the ground lead of the turntable with this terminal. This helps to reduce humming and pop
noises.
6. OPERATION
As soon as the Audio-signals are present the signal level is displayed. You can adjust the level of the input
signals via the Gain-control.
7. PROBLEM CART
PROBLEM:
No power.
• The power-cord is not connected.
No sound.
• The PHONO/LINE-switch of the respective
channel is in the wrong position.
• The power-cord of the respective device is
not connected properly or not connected at
all.
• The connection-socket or the plug is dirty.
Noise.
• The input-signal is too strong.
8. REPLACING THE CROSSFADER
Instructions for replacing the crossfader:
• Remove the fader knob.
• Remove the two outer screws on the fader-panel.
• Take the fader out and unplug the connection-cable.
• Connect the new fader and fix it in the device.
The fader-panel of the replacement-crossfader cannot be used for the Design-version. In order to exchange
the fader-panels, additionally unscrew the 2 inner screws and exchange the two fader-panels.
CAUSE:
16/31
REMEDY:
• Check the power-cord and any extension-
cables.
• Put the PHONO/LINE-switch into the
correct position.
• Check the power-cord and if the plugs are
tightly connected with the sockets.
• Clean the socket and/or the plug.
• Reduce the input-signal via the Gain-
control.
10006556_V_1_0.DOC
Publicidad
