Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610957386 04-09:BM BNS200-18 04-09 6/17/09 7:55 AM Page 13
The No-Mar Pad on the nose of the work contact element
protects the work piece from the work contact element when
the work piece contact is compressed during actuation. The
pad can be removed and replaced, figure 15.
Disconnect the air supply from the tool
W RNING
and remove nail strips before removing
or replacing no-mar pads. Such precautionary safety
measures reduce the risk or unintentional tool operation.
To remove the pad: Pull the no mar tip directly away from
tool.
To replace the pad: Push the no mar tip on to the tool
inserting the opening of the no mar tip on to the work
contact element.
Storage area for the no-mar pad can be found on the rear of
the magazine, figure 16.
A correctly sized compressor is critical for maximum tool
performance. Use the following calculation to determine the
required compressor size.
Compressor size (CFM) =
x Shots per minute x Number of tools x 1.2
Air Consumption, one shot per second @ 100 psi: 1.8 CFM
Accessories
No-Mar Pad
Compressor
ir Consumption(CFM)
60
FIG. 15
Work Contact
Element
No-Mar Pad
FIG. 16
No-Mar Pad
Storage
13
Publicidad
