Part 4
INSTALL THE RANGE
Replace the access cover on the range back. To
replace the wire cover, insert double projections in the
pockets located below the opening and tighten the
three screws.
5
ANTI-TIP DEVICE INSTALLATION
Tip - Over Hazard
A child or adult can tip the range and be killed.
Verify the anti-tip brackets have been installed.
Ensure the anti-tip brackets are enganged
when the range is moved.
Do not operate the range without the anti-tip
brackets in place.
Failure to follow these instructions can result
in death or serious burns to children and adults.
To check visually that leveling leg is inserted
into bracket, grasp the top rear edge of the
range and carefully attempt to tilt it forward.
1. Locate the brackets using the template
Two Anti-tip brackets are packaged with template. The
instructions include necessary information to
complete the installation.
Read and follow range installation instruction sheet
(template).
2. Level the range
Level the range by adjusting the leveling legs with a
wrench.
Use a spirit level to check your adjustments. Place the
level diagonally on the oven rack, and check each
direction for level.
First check direction
After check direction
If the spirit level doesn't show
level on the rack, adjust the
leveling legs with a wrench.
6
FINAL INSTALLATION
into the receptacle.
leg slides under the anti-tip bracket. Range will sit 0"
Leveling
away from the back wall when properly installed.
Anti-tip
leg
bracket
bracket engages the range back brace and prevents
tip-over.
operation as described in owner's manual.
9
.
1
.
2