Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. SAFETY INSTRUCTIONS
Warning To prevent or reduce the risk of electri-
cal shock or fire, do not expose this unit to rain or
moisture.
Caution There are no user serviceable parts inside
this unit. Do not attempt any repairs yourself. Doing
so will void your manufactures warranty. In the
unlikely event your unit may require service please
contact us.
•
Please keep this User Guide for future consulta-
tion. If you sell the unit to another user, be sure
that they also receive this instruction booklet.
•
Unpack and check carefully there is no trans-
portation damage before using the unit.
•
Before operating, ensure that the voltage and
frequency of power supply match the power
requirements of the unit.
•
It's important to ground the yellow/green con-
ductor to earth in order to avoid electric shock.
•
The unit is for indoor use only. Use only in a dry
location.
•
The unit must be installed in a location with ad-
equate ventilation, at least 50cm from adjacent
surfaces. Be sure that no ventilation slots are
blocked.
•
Disconnect main power before replacement or
servicing.
•
Make sure there are no flammable materials
close to the unit while operating as it is fire
hazard.
•
Use safety cable when fixes this unit. DO NOT
handle the unit by taking its head only, but
always by taking its base.
•
Maximum ambient temperature is Ta: 40°. Do
not operate it where the temperature is higher
than this.
•
Unit surface temperature may reach up to 85°.
Do not touch the housing bare-hand during its
operation. Turn off the power and allow about
15 minutes for the unit to cool down before
replacing or serving.
•
In the event of serious operating problem, stop
using the unit immediately. Never try to repair
the unit by yourself. Repairs carried out by
unskilled people can lead to damage or mal-
function. Please contact the nearest authorized
technical assistance center. Always use the
same type spare parts.
•
Do not touch any wire during operation as high
voltage might be causing electric shock.
Warning
•
To prevent or reduce the risk of electrical shock
or fire, do not expose the unit to rain or moisture.
•
Do not open the unit within five minutes after
switching off.
•
The housing, the lenses, or the ultraviolet filter
must be replaced if they are visibly damaged.
Caution
There are no user serviceable parts inside the unit.
DO NOT open the housing or attempt any repairs
yourself. In the unlikely event your unit may require
service, please contact your nearest dealer.
•
If using a 230V 50Hz power supply, do not con-
nect in series more than 11 units; use another
main supply for the next 11 fixtures.
•
If using a 120V 60Hz power supply, do not con-
nect in series more than 5 units; use another
main supply for the next 5 fixtures.
Installation
The unit should be mounted via its screw holes on
the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operat-
ing. And make sure that the structure to which you
are attaching the unit is secure and is able to sup-
P. 3
English version
- Tecshow Halo 80 LED
Publicidad
Tabla de contenido
