Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4. Once the connection has been made,
the receiver inserts into the down rod hanging
bracket. The canopy comes up to cover the
receiver and bracket. (Fig. 11)
Figure
11
An additional safety support is provided to
prevent the fan from falling. Secure the
Support cable to the ceiling joist with screw
and washer. Screw and Support cable holder
lock the fixed
Support
cable. (Fig. 12)
Figure
12
Installing the canopy:
Step 1. Align the locking slots of the canopy
(C) with the two screws (FF) in the mounting
bracket (A). Push up to engage the slots and to
lock in place. (Fig. 13)
Step 2. Rotate the metal cover (D) clockwise
to lock in the bottom of the canopy. (Fig. 13)
Figure
13
Installing the Fan blades, rattan shade
and bulbs:
Step 1: Install the fan blades (M) onto the fan
motor shaft (U), Put the R-shaped pin (R) into
the motor shaft (U) to lock with a screwdriver
or pliers, Left handed thread on the lock nut
(Q).Install lock nut (Q) onto the motor shaft (U)
after the fan blades (M) is installed. (Fig. 14)
(Fig. 15)
Step 2. Use the screws (H) to lock and secure
the rattan shade (E) and four square arms(G).
(Fig. 14)
Step 3. Screw light bulbs (F) into the fixture
Sockets(S). (Fig. 14)
Figure
15
Figure
14
6.
Publicidad
