Cutting Height - Husqvarna LC 451S Manual De Instrucciones

• Slide the knobs up towards the handle until they stop
and a click is heard. Tighten the knobs properly.
Transport position
The handle assembly can be folded to minimize space
needed for transport and storage.
• Loosen the lower knobs.
• Slide the knobs to the ends of the grooves on both
sides of the machine.
• Fold forward the handle.
82 – English
ASSEMBLING AND ADJUSTMENTS
Operating position
• Fold the handle to its upright position.
• Slide the knobs up towards the handle until they stop
and a click is heard.
• Screw on the handle with the knob.

Cutting height

NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
The machine is equipped with central cutting height
adjustment.
• To adjust the cutting height, press the height adjuster
towards the wheel and then move it forwards to give a
lower cutting height and backwards to give a higher
cutting height.
• The cutting height can be adjusted in 6 different steps.