Operator Presence Control (Opc); Forward And Rearward Pedals; Symbols On The Product; Cutting Height Lever - Husqvarna R112iC Manual De Usuario

Operator presence control (OPC)

The OPC sets the product in safe mode when the
operator lifts from the seat. The motor stop and the
blade motors stop if the blades are engaged. Refer to
To do a check of the operation conditions on page 13 .

Forward and rearward pedals

The speed is gradually adjusted with 2 pedals. The left
pedal (A) is used to move forward, and the right pedal
(B) is used to move rearward. The product stops when
the pedals are released.

Cutting height lever

The cutting height is adjusted in 5 (1–5) different
positions.
Note:
Lift the cutting deck before you adjust the
cutting height.
4
A
B

Symbols on the product

WARNING: This product can be
dangerous and cause serious injury or
death to the operator or others. Be careful
and use the product correctly.
Read the operator's manual carefully
and make sure that you understand the
instructions before use.
Rotating blades. Keep body parts away
from the cover when the motor is on.
Warning: Keep body parts away from
rotating parts.
Look out for thrown objects and ricochets.
Do not use the product if persons,
especially children, or animals, are near
the product.
Look behind you before and while you
move the product in reverse.
Do not cut grass across a slope. Do not
cut grass on ground with a slope larger
than 10°. Refer to
on page 10 .
Do not let other persons than the operator
sit on the product. Do not let persons sit
on the equipment.
Operate the product very slowly if no
cutting deck is attached.
Move forward.
Neutral gear.
Move rearward.
To cut grass on slopes
1263 - 006 - 27.04.2022