Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fig. C
1
Dry pick up
For everyday spills of dry material.
-
Do not fill the dust bowl
intake chute.
Optimizing the suction force
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Emptying and cleaning the product
Removing the dust bowl and filter (Fig. D, E)
WARNING:
should be cleaned regularly.
1. Press the bowl release button
3
straight off as shown in Fig. D.
2. While holding the dust bowl over a trash can, pull out
the filter
to empty the contents as shown in Fig. E.
9
3. Insert cleaned filter
9
4. To replace the dust bowl, push it back onto the handle
until it clicks firmly into place.
WARNING:
without the filters. Optimum dust collection will only
be achieved with a clean filter.
Fig. D
2
4
3
beyond the end of the
The filter is reusable and
2
and pull the dust bowl
into the dust bowl
3
.
Never use the appliance
3
Fig. E
Cleaning the dust bowl and filter
The dust bowl and filter can be washed in warm soapy
water.
1. Make sure the filter
9
before installing.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
•
Remove the old filters as described in Cleaning
the Filters.
•
Fit the new filters as described in Cleaning the Filters.
(cat. no: HNVCF10)
These fit all units. When these filters reach the end of their
lifespan they must be disposed of at a local recycling center.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.
WARNING:
completely dry before using it.
iMPORTAnT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service organizations,
always using identical replacement parts.
TROUBLESHOOTING
If the product does not work, check the following:
•
The charger was correctly plugged in for recharge. (It
feels slightly warm to the touch.)
•
The charger cord is not damaged and is
correctly attached.
•
The charger is plugged into a working electrical outlet.
For assistance with your product, visit our website
www.blackanddecker.com for the location of the service
center nearest you or call the BLACK+DECKER help line at
1–800–544–6986.
9
3
and the dust bowl
3
are dry
Make sure the vacuum is
Publicidad
