Descargar Imprimir esta página

RIB R10-CRX Manual De Instrucciones página 21

Publicidad

Idiomas disponibles

Idiomas disponibles

7. Selectable functions through dip-switch
IT IS IMPORTANT TO ADJUST THE DIP-SWITCHES POSITIONS ONLY WHEN THE CONTROL BOARD IS TURNED OFF!!!
Default settings
The control board is supplied with the dip-switches set as indicated in the Pict. 1.
In the table are sum up the functions that can be selected through these dip-switches.
2 3
4
Fig.1
7.1 Functioning on opening/closing (DIP 1 - DIP 2)
This function enables to select the method of opening/closing of the automation.
ON
ON
OFF
OFF
2 3
2 3
4
4
DIP
DIP
ON
OFF
2 3
4
DIP
ON
OFF
The automation operates in hold-to-run mode in closing.
2 3
4
DIP
The pause time for automatic closing, even if it is set, will not be implemented.
ON
OFF
2 3
4
DIP
The automation operates under pulse mode in closing.
The operating mode with "pulse function" activated can be selected by the DIP 4.
7.2 Working time (DIP 3)
The setting of this dip enables to choose between a working time manually set through a trimmer or an infinite working time.
ON
OFF
An infinite working time is set, the output remains activated till the reception of a stop or an opposite motion impulse.
2 3
4
DIP
The pause time for automatic closing, even if it is set, will not be implemented.
ON
OFF
DIP
2 3
4
The working time is manually set through the "RUN TIMER" trimmer adjustment (see paragraph 6).
TURN OFF THE POWER SUPPLY DURING THE CHANGE OF CONFIGURATION.
DIP
ON
1
Function in opening
OFF
2
Function in closing
DIP
3
Working time
4
Pulse functioning
The automation operates under dead man mode in opening.
The automation operates under pulse mode in opening.
Function
OFF
Hold-to-run
Hold-to-run
Programmable
Open - Close
21
ON
Impulse in opening
Impulse in closing
Infinite
Step by step (function GO)
G
B

Publicidad

loading

Este manual también es adecuado para:

Abj0015Abj0016