INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 48 cm (18.9 inches) wide by
85.7 cm (33.7 inches) high by 44.6 cm (17.6
inches) deep.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
OPERATING INSTRUCTIONS
FEATURES
1. Freezer compartment
2. Ice cube tray
3. Thermostat dial and push button defrost
4. Drip tray
5. Glass shelves
6. Magnetic door gasket
7. Can dispenser.
8. Bottle rack
9. Leveling feet
1
2
4
5
9
IMPORTANT
Ensure that the door is fully closed when the
appliance is in operation. Failure to fully close
the door can lead to excessive condensation
and potential water damage to fl ooring under
the appliance. Danby will not be responsible for
damages from misuse.
Note: After plugging in the refrigerator for the fi rst
time, allow it to sit empty and undisturbed for 3 - 4
hours before adding any food items to ensure that
the appliance has time to get cold.
3
3
7
8
6