Descargar Imprimir esta página

Gardena LAZER LZ11577HRB Manual De Las Instrucciones página 23

Publicidad

BAGGER PARTS
TEILE DES GRAS-AUFFANGBEHÄLTERS
PIÈCES DE RECHANGE DU RAMASSE-HERBE
1/4 x 20 x 1.25"
Carriage Bolts
Karosserieschrauben
Boulons de carrosserie
Tornillos de cabeza redonda
Bulloni a testa tonda
Slotbouten
TO ASSEMBLY BAGGER
Unfold bag and stand right side up.
Feed front bagger frame (1) up through fabric loops at each
side of bagger.
Snap bottom of front bagger frame (1) into snap feature at
front of bagger bottom.
Slide bagger fabric loop (2) segments at the ends of bag
onto top bagger frame tubing.
Uninstall two (1\4"-20 x 1.15") hex bolts (3) from the front of
top frame.
Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through holes
at top of the front bagger frame and thread into nuts inside
the tubing of top bagger frame.
Uninstall (1/4"-20) lock nuts (4) at bottom of front bagger frame.
Unfold cross braces (5) and attach to carriage bolts at bottom
corners of front bagger frame.
Reinstall (1/4"-20) lock nuts (4) and tighten until fully seated.
5
1/4 x 20 x 1.15
Shoulder Bolts
Ansatzschrauben
Flanschkontermuttern
Boulons à épaulement
Pernos de tope
Tuerca de presión con brida
Bulloni di spallamento
Borstbouten
3
1
4
PIEZAS DE LA ENSACADORA
PARTI DEL SACCO DI TELA
ONDERDELEN OPVANGBAK
1/4 x 20
Flange Lock Nuts
Federklammer-Sicherung
Écrous frein
Dadi flangiati
Flensborgmoeren
Remove clevis pin (6) and retainer spring (7) from bagger
handle (8).
Slide bagger handle (8) down through bagger cover and
frame upper weldment holes.
Reinstall clevis pin (6) through hole at bottom of bagger
handle and slide retainer spring (7) into hole at the end of
the clevis pin until it locks into place
7
2
TO ADJUST BAGGER FULL LEVER/PADDLE
Before adjusting, tractor engine must be shut off and parking
brake engaged.
3
For the heaviest/wet grasses, remove paddle (3).
For lighter grasses use the paddle (3) on setting "1", "2", or
"3" ("3" being for the lightest or dry grass).
Choose your setting and rotate the bagger paddle (3) so that
the desired number (setting) faces you.
Setting may be changed by loosening fasteners (4 and 5),
removing/rotating paddle (3), and tightening again.
23
Retainer Spring Clip
Attache à ressort
Abrazadera de
arandela de retención
Clip di fissaggio
Sluitveerklem
1
4
2
Clevis Pin
Gabelstift
Axe de chape
Pasador de horquilla
Perno
Vorkbout
8
6
2
3
5

Publicidad

loading