Descargar Imprimir esta página

Panasonic CU-5E34NBE Manual Del Usuario página 44

Ocultar thumbs Ver también para CU-5E34NBE:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65
IMPORTANT!
Please Read Before Starting
This air conditioner must be installed by the sales dealer or
installer.
This information is provided for use only by authorized
persons.
For safe installation and trouble-free operation, you
must:
Carefully read this instruction booklet before beginning.
Follow each installation or repair step exactly as
shown.
This air conditioner shall be installed in accordance
with National Wiring Regulations.
Pay close attention to all warning and caution notices
given in this manual.
WARNING
CAUTION
If Necessary, Get Help
These instructions are all you need for most installation
sites and maintenance conditions. If you require help for
a special problem, contact our sales/service outlet or
your certified dealer for additional instructions.
In Case of Improper Installation
The manufacturer shall in no way be responsible for
improper installation or maintenance service, including
failure to follow the instructions in this document.
SPECIAL PRECAUTIONS
WARNING
When Wiring
ELECTRICAL SHOCK CAN CAUSE
SEVERE PERSONAL INJURY OR DEATH.
ONLY A QUALIFIED, EXPERIENCED
ELECTRICIAN SHOULD ATTEMPT TO
WIRE THIS SYSTEM.
• Do not supply power to the unit until all wiring and tub-
ing are completed or reconnected and checked.
• Highly dangerous electrical voltages are used in this
system. Carefully refer to the wiring diagram and
these instructions when wiring. Improper connections
and inadequate grounding can cause accidental
injury or death.
following local electrical codes.
• Connect all wiring tightly. Loose wiring may cause
overheating at connection points and a possible fire
hazard.
• To prevent possible hazards from insulation
failure, the unit must be grounded.
• Install a protective leakage breaker/fuse link depend-
ing on the installation location (especially a damp or
humid location). If a leakage breaker/fuse link is not
installed, electric shock can occur.
This symbol refers to a
hazard or unsafe practice
which can result in severe
personal injury or death.
This symbol refers to a
hazard or unsafe practice
which can result in personal
injury or product or property
damage.
When Transporting
Be careful when picking up and moving the indoor and out-
door units. Get a partner to help, and bend your knees when
lifting to reduce strain on your back. Sharp edges or thin
aluminum fins on the air conditioner can cut your fingers.
When Installing...
Select an installation location which is rigid and strong
enough to support or hold the unit, and select a location
for easy maintenance.
...In a Ceiling or Wall
Make sure the ceiling/wall is strong enough to hold the
unit's weight. It may be necessary to construct a strong
wood or metal frame to provide added support.
...In a Room
Properly insulate any tubing run inside a room to prevent
"sweating" that can cause dripping and water damage to
walls and floors.
CAUTION
...In Moist or Uneven Locations
Use a raised concrete pad or concrete blocks to provide
a solid, level foundation for the outdoor unit. This pre-
vents water damage and abnormal vibration.
...In an Area with High Winds
Securely anchor the outdoor unit down with bolts and a
metal frame. Provide a suitable air baffle.
...In a Snowy Area
• Position the outdoor unit in a protected location where
snow will not blow into it.
• Install the outdoor unit on a raised platform that is high-
er than drifting snow. Provide snow vents.
When Connecting Refrigerant Tubing
WARNING
• Ventilate the room well, in the event that refrigerant
gas leaks during the installation. Be careful not to allow
contact of the refrigerant gas with a flame as this will
cause the generation of poisonous gas.
2
Keep the fire alarm and the
air outlet at least 1.5 m away
from the unit.
• When performing piping work
do not mix air except for
specified refrigerant (R410A)
in refrigeration cycle. It caus-
es capacity down, and risk of
explosion and injury due to
high tension inside the
refrigerant cycle.
• Refrigerant gas leakage may
cause fire.
• Do not add or replace refriger-
ant other than specified type.
It may cause product dam-
age, burst and injury etc.

Publicidad

loading

Este manual también es adecuado para:

Cu-5e34nbe-c1 852 362 21