Publicidad
Idiomas disponibles
Idiomas disponibles
V
Placement precautions
o Do not install this unit in a location that could become hot.
This includes places that are exposed to direct sunlight or near
a radiator, heater, stove or other heating equipment. Moreover,
do not place it on top of an amplifier or other equipment that
generates heat. Doing so could cause discoloration, deformation
or malfunction.
o Avoid locations that are extremely cold or exposed to excessive
humidity or dust.
o When installing this unit, leave a little space (at least 3 cm or 1")
between it and walls and other devices in order to allow good
heat dissipation. If you put it in a rack, for example, leave at least
5 cm (2") open above it and at least 10 cm (4") open behind it.
Failure to provide these gaps could cause heat to build up inside
and result in fire.
o The voltage supplied to the unit should match the voltage
printed on the back of the unit. If you are in any doubt regarding
this matter, consult an electrician.
o Do not move the unit during use.
o Do not open the body of the unit because this could result in
damage to the circuitry or cause electric shock. If a foreign object
should enter the unit, contact your dealer.
o When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord.
Note about placement
The steel feet are loosely attached to the bottom of the unit, leaving
slight gaps. For this reason, the feet will move slightly from the bot-
tom when the unit is lifted.
This unit is designed to rest on the feet when it is placed so that the
feet do not apply unnecessary stress to the body.
o The feet will move slightly from the bottom of the unit, but this is
not a defect.
o Apply the included pads to the bottoms of the foot-stands to
avoid scratching the surface where the unit is placed.
The top panel of this unit is attached with some play.
o The panel will move slightly, but this is not a defect.
Before use
Wipe dirt from the top cover and other panel surfaces using a
soft cloth that has been slightly dampened with a diluted neutral
cleanser.
Do not wipe with chemical cleaning cloths, thinner or other chemi-
cal agents. Doing so could damage the surface.
V
You can download updates for this unit from the TEAC International
Site:
https://teac.jp/int/
Click Language at the top right of the page and select the desired
country or region to access a page in the corresponding language.
For your safety, disconnect the power cord from
the outlet before cleaning.
Using the TEAC International Site
Maintenance
7
EN
Publicidad
