Publicidad
2.
Adjust the Handle Assembly
A
B
C
Mixed Water Supply
Alimentation d'eau mélangée
Suministro de agua mezclada
NOTE: Valve Operation. Water will flow from a single shower accessory when the
control knob detent lines up with any of the markings on the escutcheon. Water will
flow from two accessories at the same time when the control knob detent is midway
between the markings.
Ensure the valve stem adapter is lightly placed over the spline adapter.
Place the handle assembly over the valve stem adapter.
Turn on the water supply to the transfer valve.
Rotate the handle assembly until water begins to flow through the shower
accessory.
Determine the shower accessory that will correspond to the Accessory "A" setting
at the vertical 12 o'clock position on the escutcheon for the 3-way installation or 4
o'clock for the 2-way installation.
Turn the handle to the detent setting that corresponds with Accessory "A." The
handle should be in the vertical 12 o'clock position for the 3-way installation or 4
o'clock for the 2-way installation.
Repeat for each detent.
Remove the handle assembly and set aside.
To adjust for handle alignment:
NOTE: The spline adapter allows fine adjustment of the handle alignment.
Remove the valve stem adapter.
Reposition the spline adapter.
Reinstall the valve stem adapter and the handle assembly.
Check the alignment. Repeat this procedure until the handle alignment is
satisfactory.
Kohler Co.
Spline Adapter
Adaptateur à cannelures
Adaptador de ranuras
Valve Stem Adapter
Adaptateur de tige de valve
Adaptador de la espiga de la válvula
Handle Assembly
Ensemble de poignée
Montaje de manija
A + C
C
B
A
B + A
2-Way/2 voies/2 vías
3-Way/3 voies/3 vías
5
A
A + B
B
B + C
1160375-2-A
Publicidad
