Clarke American Sanders 07057A Manual Del Operador página 11

Sander Adjustment Procedures
DANGER: Electrocution could occur if maintenance
And repairs are performed on a unit that is not
properly disconnected from the power source.
Disconnect the power supply before attempting
any maintenance or service.
DANGER: Moving parts of this machine can cause
Serious injury and/or damage. Keep hands,
feet and loose clothing away from all
moving parts of the sander.
The following information provides details on how to
adjust different features/controls of the sander.
Dust Shoe
To adjust the dust shoe follow this procedure:
1. Disconnect machine from power supply.
2. Loosen the four screws fastening the dust shoe to
the chassis.
3. Adjust the dust shoe towards the drum to improve
recovery of fi ne particles.
4. Adjust the dust shoe away from the drum to improve
recovery of coarse particles.
5. Align the dust shoe with the drum and tighten
screws. See fi gure # 12.
Leveling
To adjust the machine leveling follow this procedure:
1. Locate the leveling screw. See fi gure # 13.
2. Tighten the screw (compress the leveling spring) to
sand heavier on drive belt side of sanding drum.
3. Loosen the leveling screw (relax the leveling spring)
to sand heavier on the side opposite the drive belts.
®
American Sanders Operator's Manual (EN) - EZ-8 Sander
Clarke
ENGLISH
Figure # 12
Figure # 13
Form No. 78425C
EN
- 11 -