Futurelight MCF-200 Manual Del Usuario página 25

Note:
After switching on, the MCF-200 will automatically detect whether DMX 512 data is received or not. If the
data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights
up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the MCF-200.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control channel 1 - Rotation
DMX-value Feature
0-19 No rotation
20-135 Rotation clockwise
136-139 No rotation
140-255 Rotation anti-clockwise
Control channel 2 -– Gobos, Reset, Strobe
DMX-value Feature
0-7 Closed
8-15 Open
16-23 Gobo 1
24-31 Gobo 2
32-39 Gobo 3
40-47 Gobo 4
48-55 Gobo 5
56-63 Gobo 6
64-71 Gobo 7
72-79 Gobo 8
80-87 Gobo 9
88-95 Gobo 10
96-103 Gobo 11
104-111 Gobo 12
112-119 Gobo 13
120-127 Gobo 14
128-132 Closed
133-137 Reset (after 3-5 seconds)
138-159 Forwards gobo-change with increasing speed
160-200 Strobe effect with increasing speed
201-250 Random strobe effect with increasing speed
251-255 Open
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
25/51 51837550X18NXS_V_1_1.DOC