Publicidad
Idiomas disponibles
Idiomas disponibles
Attention! This interface will work with models that are either non-amplified, or amplified. Please follow
the instructions carefully for your model vehicle. Failure to do so will result in either no sound, or low
sound. If you are unsure if your vehicle is factory amplified or not, please contact your local dealership.
For models without an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio (harness included with interface):
• Connect the Red wire to the accessory wire.
Note: If installing an ASWC-1 (sold separately), connect the Red wire on the AX-ADCH01
harness as well.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
Attention! The following (4) wires are reversed on purpose. These wires will not match "color
code" to the aftermarket radio.
• Connect the Gray wire to the right rear positive speaker output.
• Connect the Gray/Black wire to the right rear negative speaker output.
• Connect the White wire to the left rear positive speaker output.
• Connect the White/Black wire to the left rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following (6) wires, they will not be used in this application:
Blue/White, Brown, Green, Green/Black, Purple, Purple/Black
CONNECTIONS TO BE MADE
From the AX-ADCH01 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• If installing an ASWC-1 (sold separately), connect the Red wire to accessory power.
• Connect the Blue/White wire to the power antenna wire.
• Ensure the (2) 4-pin Molex connectors (with green and purple wires) are connected together.
• Connect the 4-pin harness with stripped leads, to the 4-pin Molex connector
Attention! The following (4) wires are reversed on purpose. These wires will not match "color
code" to the aftermarket radio.
• Connect the Green wire to the right front positive speaker output.
• Connect the Green/Black wire to the right front negative speaker output.
• Connect the Purple wire to the left front positive speaker output.
• Connect the Purple/Black wire to the left front negative speaker output.
12-pin pre-wired ASWC-1 harness:
(with gray and white wires).
This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If the ASWC-1
will be used, please refer to the ASWC-1 instructions for radio connections and programming.
Disregard the harness that comes with the ASWC-1.
Continue to Installing & Programming the AX-ADCH01
REV. 6/22/2018 INSTAX-ADCH01
3
Publicidad
