HQ-Power ILBA001 Manual Del Usuario página 7

• Output brightness too low
Check the output connections and controller input voltage.
• Overheating of the controller
Make sure the controllers' input voltage is not too high and check whether
there is sufficient ventilation.
• In linked mode, controllers don't work synchronously.
Check the data terminals and the length of the data bus. Press any key on
the remote control to start synchronizing.
• Remote control is not working
Point the remote control straight towards the IR receiver, check the
distance (<7m). Replace the battery.
10. Technical specifications
input voltage
output power
max. output for each loop
IR remote control working distance
dimensions
Weight
power supply remote control
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulted from (incorrect) use
of this device.
For more info concerning this product, please visit our website
www.hqpower.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written consent of the copyright
holder.
Referencia Electrónica Embajadores: ILBA001
09.09.2009
Controller
IR remote control
Controller
IR remote control
CHLSC1
12 or 24VDC
180W (12VDC) or 360W (24VDC)
60W (12VDC) or 120W (24VDC)
7m
121 x 51 x 26mm
90 x 49 x 7mm
±110gr
±22gr
3V lithium CR2025, incl.
7
©Velleman nv