STARTING PROCEDURE
STEP #1)
Pump the "PRIMER BULB" under of the
carburetor until fuel can be seen flowing
through the "FUEL-RETURN LINE".
PRIMER
BULB
FUEL
RETURN LINE
Left throttle
STEP #3)
Turn the stop switch ON. (Confirm that the
stop switch is at the starting position.)
Set the throttle lever at 1/2 speed.
1/2 SPEED
CAUTION!
Press down the "AIR FILTER COVER" and Pull the
"STARTER GRIP" briskly to start the engine.
NOTE: Only short pulls are necessary. Never pull the
starter cord to its fullest extension. Never let go of the
starter grip until it is at the fully returned position.
English
OPERATING INSTRUCTIONS
STOP
START
STEP #2)
Move the "CHOKE LEVER" fully up ward to
the closed position. If the engine is already
warm, only a partial or open (no choke) choke
setting may be required.
CLOSE
CHOKE
LEVER
OPEN
Right throttle
STEP #3)
Set the throttle lever at 1/2 speed.
— 15 —
HIGH SPEED
IDLE SPEED
STOP
STARTER GRIP