Publicidad
Idiomas disponibles
Idiomas disponibles
5 ] Remove 7" Round Duct Plate from top/back of hood (see illustration below).
7" ROUND
DUCT
PLATE
2 SCREWS
1 ] Remove Electrical Power Cable Knockout from top (vertical wiring) or back (horizontal wring)
of hood. Install an appropriate strain relief, 1/2" diameter (not included).
ELECTRICAL
POWER CABLE
KNOCKOUT
NON-DUCTED INSTALLATION ONLY
2 ] Remove 3 screws retaining the recirculation cover plate (shaded part in illustration below)
to the hood. Discard this plate with its screws.
SCREWS
RECIRCULATION
COVER PLATE
10
Publicidad
