that sparks fly away from you and other
persons or flammable materials.
29. Do not leave the tool running. Operate the tool
only when hand-held.
30. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
31. Always be sure that the tool is switched off
and unplugged or that the battery cartridge is
removed before carrying out any work on the
tool.
32. Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
33. Do not use separate reducing bushings or
adaptors to adapt large hole abrasive wheels.
34. Use only flanges specified for this tool.
35. For tools intended to be fitted with threaded
hole wheel, ensure that the thread in the wheel
is long enough to accept the spindle length.
36. Check
that
supported.
37. Watch out for flying sparks. Hold the tool so
that sparks fly away from you and other
persons or flammable materials.
38. Pay attention that the wheel continues to
rotate after the tool is switched off.
39. If working place is extremely hot and humid, or
badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure
operator safety.
40. Do not use the tool on any materials
containing asbestos.
41. Do not use water or grinding lubricant.
42. Ensure that ventilation openings are kept clear
when working in dusty conditions. If it should
become
necessary
disconnect the tool from the mains supply
( use non metallic objects ) and avoid
damaging internal parts.
43. When use cut-off wheel, always work with the
dust collecting wheel guard required by
domestic regulation.
44. Cutting discs must not be subjected to any
lateral pressure.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
SAVE THESE INSTRUCTIONS.
the
workpiece
is
to
clear
dust,
Symbols
The followings show the symbols used for tool.
FUNCTIONAL DESCRIPTION
properly
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Shaft lock
009422
first
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
009423
6
・
volts
・
amperes
・
hertz
・
alternating current
・
no load speed
・
Class II Construction
・
revolutions or reciprocation per minute
1
1
USD201-2
1. Shaft lock
1. Switch lever