American Standard Studio S TU105740 Instrucciones De Instalación

Studio S
®
Flash 2-Handle Integrated Diverter
™
Pressure Balance Valve Trim
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
ROUGHING-IN DIMENSIONS
FINISHED
WALL
Ø 7-7/8"
(200 mm)
CARE INSTRUCTIONS:
• To keep your new faucet looking new, please follow
these simple care instructions:
DO: – Simply rinse the faucet clean with clear water.
– Dry the faucet with a soft cotton cloth.
DO NOT:
– Do not use any abrasive cleaners, cloths,
or paper towels.
– Do not use any cleaning agents containing
acids, polish abrasives, or harsh cleaners
or soaps.
• Regular and routine cleaning will reduce the need for
heavy cleaning and polishing. If heavy cleaning is
required, the following procedures are recommended:
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2021
INSTALLATION
INSTRUCTIONS
Phillips Screwdriver
3-5/8"
(93 mm)
2-3/4"
(69 mm)
(169 mm)
- 1 -
TU105740
Flat Blade Screwdriver
6-5/8"
• Remove as much surface dirt and film using clear
water and soft cotton cloth (as described above).
– Use any of the following to remove tough surface
film and build-up:
– Mild liquid detergents
– Clear ammonia free liquid glass cleaners
– Non-acidic, non-abrasive gentle liquid or fully dissolved
powder cleansers mixed according to manufacturers
directions
– Non-abrasive liquid polishers
• Once clean, rinse faucet again with clear water to
thoroughly remove cleaner or polish and blot dry with
a soft cotton cloth.
Failure to follow these care instructions may damage
the Faucet's finish.
Certified to comply with ANSI A112.18.1M
Ø 7-7/8"
(200 mm)
M985082 (1/21)