Publicidad
Idiomas disponibles
Idiomas disponibles
The auxiliary handle (12) can be mounted in three different
positions to adapt the power tool to the work to be done
and make easier its handling.
1. Insert the clamping screw of the auxiliary handle into
one of the grinder fixing threads;
2. Screw the auxiliary handle in clockwise until it is fully
tightened in place.
The position of the disc guard can be adjusted according to
suit the working conditions. The disc guard must be fitted
on the tool so that the closed side of the guard always
points toward the operator.
1. Install the disc guard (13) with the protrusion on the
guard band aligned with the notch of the gear housing
(4);
2. Turn the disc guard according to the desired position;
3. Tighten the guard locking screw (3);
4. To remove the disc guard, follow the installation
procedure in reverse.
1. Make sure that the disc guard (13) is securely fitted;
2. Place the inner flange (2) onto the spindle. Make sure
that the inner flange is properly fitted on the spindle;
3. Fit the cutting disc (1) in the inner locking flange of the
disc. Make sure the disc is correctly installed;
4. Place the outer flange of the disc (2) onto the spindle:
- For cutting discs, the outer locking flange of the disc is
placed with the protrusion facing away from the disc;
- For grinding discs, the outer locking flange of the disc
is placed with the protrusion facing away from the disc;
5. Press the spindle lock button (5) and rotate the disc by
hand until it locks. Keep the spindle lock button pressed
in and tighten the outer flange with the supplied
spanner;
6. As a precaution, perform a test to check the correct
installation of the rotating accessory;
7. To remove the disc, follow the installation procedure in
reverse.
Wear protective gloves when installing accessories.
The power tool has been designed to cut, sharpen, grind
and polish metal and stone materials without using water.
While operating the appliance some precautions must be
taken into account:
▪
Always hold the angle grinder with both hands and with
the auxiliary handle installed;
▪
Do not apply too much pressure over the work
piece/object. The angle grinder's weight is enough to
apply the necessary pressure. If speed drops abruptly,
the pressure should be reduced immediately;
▪
Never turn the angle grinder on if the rotary accessory is
touching the workpiece. The rotary accessory must not
touch the workpiece until the maximum speed has been
reached;
▪
Keep an angle of 15° between the disc and the workpiece
surface. This procedure increases the grinding capacity
of the disc and will avoid unnecessary overloading;
▪
Do not use water or grease during the sharpening
process;
▪
Do not use a cutting disc for grinding, and vice versa;
▪
To attach accessories to the spindle thread, make sure
that the rotating accessory thread (type and dimensions)
match the accessory thread;
▪
Do not use the cutting disc to sharpen sideways. Cutting
discs must not be subjected to any lateral pressure;
▪
Use special care when working corners, sharp edges.
Prevent the accessory from bouncing or getting stuck in
the workpiece;
▪
The power cord must always be behind the appliance
during operation.
Publicidad
