Publicidad
Idiomas disponibles
Idiomas disponibles
FAULT
Unsatisfactory washing result.
As soon as the machine is
loaded with water, water dis-
charges.
No water appears in the drum
during washing.
Laundry has detergent residue.
Grey spots appear on the
laundry.
The spin cycle does not take
place or takes place later than
expected.
(*) See the chapter regarding maintenance and cleaning of your machine.
(**) See the chapter regarding installation of your machine.
POSSIBLE CAUSE
Hard water.
Your laundry is too tightly pa-
cked together in the drum.
The end of water drain hose is
too low for the machine.
No fault. Water is in the unseen
part of the drum.
Non-dissolving particles of
some detergents may appear
on your laundry as white spots.
There is untreated oil, cream or
ointment on your laundry.
No fault. The Unbalanced
load control system has been
activated.
TROUBLESHOOTING
Increase the amount of
detergent following the
manufacturer's instructions.
Check that your laundry is
spread out.
Check that the drain hose is at a
suitable height. (**) .
. . . . . . . . . . . . . . . . . . . . .
Perform an extra rinse, or clean
your laundry with a brush after
it dries.
Use the amount of detergent as
instructed on the packaging in
the next wash.
The Unbalanced load control
system will try to spread your
laundry. The spinning cycle
will begin once your laundry is
spread. Load the drum evenly
for the next wash.
93
Publicidad
