Publicidad
Idiomas disponibles
Idiomas disponibles
THE FAULT INDICATOR LIGHTS
Your Washing Machine is equipped with a built-in fault detection system, indicated by a combination
of flashing wash operation lights. The most common failure codes are shown below.
Display
indication
E01
The door of your machine
is not shut properly.
E02
The water pressure or
the water level inside the
machine may be low.
E03
The pump is faulty or
pump filter is clogged or
electrical connection of
the pump is faulty.
E04
Your machine has exces-
sive amount of water.
(*) See the chapter regarding maintenance and cleaning of your machine.
94
Reason
Explanation
Shut the door properly until you hear a click. If your machine persists
to indicate fault, turn off your machine, unplug it and contact the
nearest authorised service agent immediately.
Check the tap is fully turned on. Mains water may be cut-off. If the
problem still continues, your machine will stop after a while automat-
ically. Unplug the machine, turn off your tap and contact the nearest
authorised service agent.
Clean the pump filter. If the problem persists, contact the nearest
authorised service agent. (*)
Your machine will discharge water by itself. Once the water has
drained, turn off your machine and unplug it. Turn off the tap and
contact the nearest authorised service agent.
Publicidad
