Ryobi LTS180 Manual De Utilización página 7

EN
FR DE ES IT NL
3. Bevel scale
4. Bevel lock knob
5. Edge guide lock knob
6. Cutting wheel
7. Base
8.
9. Water bottle release button
10. Water bottle
11. Depth lock knob
12. Wheel wrench storage
13. Battery pack (not included)
14. Switch trigger
15. Inner wheel washer
16. Wheel
17. Outer wheel washer
18. Wheel screw
19. Incorrect method of support
20. Correct method of support
21. Edge guide
22. Handle, insulated gripping surface
ASSEMBLY
ATTACHING GRAVITY FEED WATER BOTTLE
The gravity feed water bottle has a built in air vent that
Remove the battery.
Unscrew the nozzle assembly.
Fill water bottle to desired level. Do not overfill.
Replace nozzle assembly.
Hold water bottle so that nozzle faces down.
NOTE: Water will not escape the bottle unless the tip
of the nozzle is depressed.
Insert the water bottle as shown. Gently press down
on the bottle until it clicks into place.
To remove water bottle, depress the water bottle
release button.
NOTE: For dry cutting, leave water bottle installed to
prevent dust and debris from clogging the water supply
system.
CAUTION
Water bottle is designed for water only. Use of any other
PT DA SV FI NO RU
English
PL CS HU RO LV LT
A 101.6 mm wheel is the maximum wheel capacity of
the saw. Also, never use a wheel that is too thick to
the spindle. Larger wheels will come in contact with the
wheel guards, while thicker wheels will prevent wheel
screw from securing wheel on spindle. Either of these
situations could result in a serious accident.
Do not use cutting wheels rated less than the no load
speed of this tool. Failure to heed this warning could
gaps, or teeth.
Do not use toothed or segmented wheels. Use only
continuous rimmed diamond wheels suited for masonry
materials.
INSTALLING CUTTING WHEEL
Remove the battery pack from the saw.
Remove the wheel wrench (5 mm hex key) from the
storage area.
Depress the spindle lock button and remove the wheel
screw and outer wheel washer.
NOTE: Turn the wheel screw clockwise to remove.
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop before
engaging spindle lock.
NOTE: Do not run the saw with spindle lock engaged.
Wipe a drop of oil onto the inner wheel washer and
outer wheel washer where they contact the wheel.
If inner wheel washer has been removed, replace it
before placing cutting wheel on spindle. Failure to do
so could cause an accident since wheel will not tighten
properly.
Replace the outer wheel washer.
Depress the spindle lock button, then replace the
3
ET HR SL SK BG UK
WARNING
WARNING
WARNING
CAUTION
WARNING
TR EL