Ryobi LTS180 Manual De Utilización página 9

EN
FR DE ES IT NL
rough. For more depth of cut accuracy, a scale is located
on the rear bracket.
Determine the desired depth of cut.
Locate the depth of cut scale on the rear bracket.
Hold the base flat against the workpiece and raise or
lower the saw until the indicator mark on bracket aligns
with the notch on the wheel guard.
OPERATING THE SAW
It is important to understand the correct method for
learn the correct and incorrect ways for handling the saw.
WARNING
When lifting the saw from the workpiece, the wheel is
exposed on the underside of the saw.
To make the best possible cut:
Hold the saw firmly with both hands.
Avoid placing your hand on the workpiece while
making a cut.
Support the workpiece so that the cut (kerf) is always
to your side.
Support the workpiece near the cut.
Clamp the workpiece securely so that the workpiece
will not move during the cut.
Always place the saw on the workpiece that is
supported, not the "cut off" piece.
Place the workpiece with the "good" side down.
Draw a guideline along the desired line of cut before
beginning your cut.
MAKING CUTS
Always draw the line to be cut on the tile using a marker or
grease pencil. If the tile is shiny and hard-to-mark, place
masking tape on the tile and mark the tape.
A common problem when cutting tile is straying from the
marked line. Once you've strayed from the mark, you
can not force the wheel back to the line by twisting the
tile. Instead, back up and recut the tile slicing off a small
amount of tile until the wheel is back on track.
To avoid this problem, use a straight edge guide whenever
possible for making cross cuts and miter cuts. If wet
cutting is desired, it should be performed outside.
PT DA SV FI NO RU
English
PL CS HU RO LV LT
USING THE EDGE GUIDE
Use the edge guide when making long or wide rip cuts
with the saw.
1. Remove the battery pack from the tool.
2. Place the edge guide through the slots in the saw
base.
3.
4. Tighten the wing screw securely.
When using an edge guide, position the face of the edge
a true cut without pinching the blade. The guiding edge of
the workpiece must be straight for your cut to be straight.
Use caution to prevent the blade from binding in the cut.
MAINTENANCE
When servicing, use only original RYOBI replacement
parts. Use of any other parts may create a hazard or
cause product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
Do not abuse power tools. Abusive practices can
damage tool as well as workpiece.
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
in a hazardous condition leading to possible serious
5
ET HR SL SK BG UK
WARNING
WARNING
WARNING
TR EL