Black and Decker Digital Advantage Serie Uso Y Cuidado página 4

CTOKT6300Pub1000002464 7/15/05
How to Use
This product is for household use only.
GETTING STARTED
• Remove packing materials and any stickers. Peel off clear protective film from electronic
control panel.
• Wash all parts as instructed in Care and Cleaning.
• Select a location for the unit. Leave some space between the back of the unit and your counter
to allow heat to flow without damaging counter space.
• Insert crumb tray underneath the bottom heating elements.
SETTING THE CLOCK
1. Plug unit into a standard wall outlet. 12:00 flashes on the digital display.
2. Press . Use and
Tip: To speed up the time sequence, press and hold the control.
3. Once you reach the correct time, press
Note: If power is interrupted, you will need to set the time again.
USING SLIDE RACK
The slide rack must be used for all cooking functions. It may be inserted in either the upper
or lower rack slot. It can also be inverted for two additional positions (C).
Upper slot
(use rack positions 1 and 3)
Lower slot
(use rack positions 2 and 4)
Slide Rack Positions
1 - Bottom down
3 - Top down
C
TOASTING BREAD OR BAGELS
or
Note: The toasting time and temperature are preset and cannot be adjusted.
1. Open oven door.
2. Place up to 6 slices of bread or 6 bagel halves on the slide rack. It is not necessary to preheat
the oven for toasting.
Note: For best performance, use rack positions 2 and 3 (C).
3. Close oven door.
2:50 PM Page 6
to set the time of day.
.
2 - Bottom up
4 - Top up
5
4. For toasting bread, press ; the digital display shows TOAST. For bagels, press
the digital display shows TOAST BGL. In both modes, you see a blinking 4 (the preset toast
shade level) and four bars on the digital display. The ON indicator light blinks for 5 seconds.
Important: You have only 5 seconds to press
display goes back to the time of day and the ON indicator light goes out. You will have to restart
the routine.
5. Use and to select desired toast/bagel shade level (from 1 to 7). For best
results, select the medium setting (4) for your first cycle, then adjust lighter or darker to suit your
taste.
6. After you press , ON indicator light becomes steady and the toast cycle begins. The
selected toast shade setting blinks throughout the toasting cycle.
7. Once toasting cycle is finished, you hear 5 short beeps. The ON indicator light goes out and the
digital display changes to the time of day.
Note: For your convenience, the unit will remember the last programmed toast setting.
8. Open oven door and using an oven mitt or pot holder, slide out the rack to remove bread or
bagels.
Caution: The unit is hot. Do not let any part of your skin touch any surface.
BAKING
Note: The oven will automatically preheat to the temperature you set for baking.
1. Press . The digital display shows BAKE and flashes 350°F (180°C). The On indicator
light blinks for 5 seconds.
Important: You have only 5 seconds to press
display goes back to the time of day and the ON indicator light goes out. You will have to restart
the routine.
2. To set desired temperature:
• For Celsius, press then use
• For Fahrenheit, press then use
of 25°.
3. Once you select desired temperature, if you want to preset baking time, press
For 5 seconds, digital display shows blinking 1:00 (default time) and BAKE TIMER.
Use and to change default time (1:00) until it reaches desired baking time.
Note: You can program the timer for up to 2 hours.
Important: You have only 5 seconds to press
or , the digital display goes back to
the time of day and the ON indicator light goes out. You will have to restart the routine.
4. Press . The digital display starts blinking LO then Preheat.
5. Open oven door. The oven beeps.
6. Place bake pan (drip tray) or pizza pan containing food on the slide rack (see Cooking Chart for
recommended rack positions).
7. Close oven door. The oven will beep at 1-minute interval and the ON indicator light keeps
blinking to signal that you MUST press
Important: Every time you open the oven door, you must press
function. If you do not press , the ON indicator light keeps blinking and the oven beeps
signaling that the Bake function is not active and the oven is not heating.
8. After you press , the ON indicator light becomes steady and digital display keeps
blinking LO then Preheat until oven reaches set temperature. The Oven then beeps and digital
display blinks between set temperature and set baking time. The Timer starts countdown to set
baking time.
. If do not press , the digital
. If you do not press , the digital
and to change in increments of 10°.
and to change it in increments
.
or . If you do not press
again to activate the baking function.
to activate the baking
6
;