Publicidad
Idiomas disponibles
Idiomas disponibles
EngLIsh
To Install advancing Mechanism
1. With the collated magazine attachment removed from
screwdriver, align the tabs
slots
13
in the collated housing.
2. Push in slightly, then align the spring
the advancing mechanism.
3. Push advancing mechanism in until you hear the "click" of
the service button. The release lever
place in its slot. You may need to pull down on the lever to
help it if it does not click in place.
nOTE: The release lever
(as shown in Figure E) before the advancing mechanism is
installed. If in the up position, the advancing mechanism will
be locked in place.
4. Cycle the advancing mechanism several times by hand
to ensure proper function before installing it onto your
screwdriver for use.
Removable Shoe (Fig. F)
Removing the shoe allows closer access to corners.
1. To remove shoe
7
on front of the unit, remove the two
screws
15
using a T10 Torx. Pull shoe straight off to remove.
2. To reinstall, push shoe onto advancing mechanism until
screw holes line up. Reinstall screws.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
•
PH2 Extended Bit x 5 - DT20425
Protecting the Environment
Separate collection. Products marked with this symbol
must not be disposed of with normal household waste.
Products contain materials that can be recovered
or recycled reducing the demand for raw materials.
Please recycle electrical products according to local provisions.
Further information is available at www.2helpU.com.
14
on the shoe with the
12
14
with the pocket in
should click into
11
11
should be in the down position
WALT recommended
e
Publicidad
