Cole-Parmer essentials SI-200 Serie Manual De Instrucciones página 3

SHAKING INCUBATORS
SI-200D, SIC-200D-L and
SIC-200D-C
Instructions for use
1. Introduction
Thank you for purchasing this piece of
Cole-Parmer equipment. To get the best
performance from this equipment please read
these instructions carefully before use. Before
discarding the packaging check that all parts are
present and correct.
Item number
HH179(S)
HH180(S)
SI600-89
I/FCALUSB
RSSL1 or SI600/1
7001096
SI600-214
SIC-200D-L and
SIC-200D-C
SIC-200D-C only:
SI600C-232
SI600C-233
SI600C-240
SI600C-241
SBS4074
700198
For your own safety and that of others please
read and understand the safety advice given
below before using the equipment.
2. Safety advice before use
If the equipment is not used in the manner
described in this manual and with
accessories other than those recommended
by Antylia Scientific, the protection
provided might be impaired.
Description
UK mains lead with plug
EU mains lead with plug
Instruction manual
USB cable
Securing bars (4)
Guarantee card
Foot brackets (2) and
screws (4) for
Washer (2)
90° connectors (2)
Condensate tubing (2)
Coolant tubing (2)
Jubilee clip (1)
Jubilee clips (4)
This equipment is designed to operate under the
following conditions:
❖ For indoor use only
❖ Use in a well ventilated area
❖ Ambient temperature range +5ºC to +40ºC
❖ Altitude to 2000m
❖ Relative humidity not exceeding 80%
❖ Mains supply fluctuation not exceeding 10%
❖ Over-voltage category II IEC60364-4-443
❖ Pollution degree 2
Operational warnings and conditions:
CAUTION: HEAVY OBJECT. DO NOT
ATTEMPT TO LIFT OR CARRY THE UNIT
ALONE.
❖ Use with a minimum distance all around of
200mm (100mm at the rear) from walls or
other items.
❖ Not to be used to heat or mix materials which
could result in liberation of gases, or cause
explosions or implosions.
❖ Not to be used or placed in areas known to
be hazardous.
❖ Never move or carry the unit when in use or
connected to the mains electricity supply.
❖ When lifting or moving the unit, always lift
from the base.
❖ Do not use in a hazardous atmosphere or
with hazardous materials.
❖ Ensure that the load is balanced.
❖ Do not attempt to stop movement by hand.
❖ Do not lean on the open door of the
SIC-200D-L or SIC-200D-C as this could cause
the unit to tilt, particularly when the platform
is extended. Furthermore, do not leave the
incubator unattended with the door open.
❖ Fitting of feet brackets to the SIC-200D-L and
SIC-200D-C is required prior to use (see 4.4).
❖ In the case of mains interruption, the unit will
not restart on restoration of the electricity
supply. In the case of mechanical interruption,
(e.g. motor stall), the unit will continue
operating on removal of interruption.
❖ Mechanical energy can lead to breakage of
glass vessels. Use with care.
USE CAUTION WHEN REMOVING VESSELS
FROM THE INCUBATOR AS PARTS MAY BE
HOT.
1