THOMSON MIC200IBT Manual Del Usuario página 20

• If the liquid contained in the batteries comes in contact with eyes or skin, wash the area immediately
and carefully with clear water and consult a doctor.
Unit power supply (mains 230V/50Hz)
Connect the power cable plug to the (230V) wall outlet.
Warning:
• Before using the unit, check that the local mains supply is compatible with the unit 230V (50Hz).
• Do not plug or unplug the power cable when your hands are wet.
• When planning not to use this unit for long periods of time (i.e. vacation etc.), disconnect the plug
from the wall outlet.
• When disconnecting the power cord from the wall outlet, grasp the plug; do not pull the cord in order
to avoid shock risks caused by the damaged cable.
Operation
Press the POWER/SOURCE button to turn ON and press and hold to power OFF the unit.
Adjusting the volume
Rotate the Volume knob clockwise to increase the volume.
Rotate the Volume knob anti-clockwise to decrease the volume.
Check the display, which will confirm the volume setting.
Mute function
Press the MUTE button on the remote control. The volume is muted and "Volume Muted" will appear
on the LCD display. Press this button again to cancel the mute function.
Clock and Timers
Setting the clock and date
After the unit is plugged into a mains supply or following a mains power failure, the display will show the
current time and date on the LCD display. The unit should be in standby mode to set the current clock.
1. Press the CLOCK button. "Time setup" is displayed, press ENTER to confirm and "time wizard
interval" is displayed.
2. Press /
will blink.
3. Press /
will blink.
4. Press /
Setting the alarm
Note: Check that the radio has the correct time and date before you set an alarm.
This unit may be used as an alarm clock. The CD/USB device or FM radio is activated to play at a
preset time.
1. Press POWER to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press the ALARM button in shutdown state;
4. "Alarm Setup" is displayed. Press the ENTER button to select.
5. "Alarm Wizard On time" is displayed and the hour digits for the alarm will flash.
6. Press /
7. Press /
8. Press /
9. Press /
10. Press the /
minutes. Press the ENTER button to select. Press
save the alarm.
11. The display will show the current time and Alarm.
to select "24H" or "12H". Press ENTER to confirm. The hour digits on the display
to set the hour and press ENTER to confirm. The minutes digits on the display
to set the Day, press ENTER confirm. Press
repeatedly to set the hour. Press ENTER to confirm.
to set the minutes. Press ENTER to confirm.
to select the Alarm volume from 0 to 32. Press ENTER to confirm.
to scroll to OFF/CD/FM/USB/BUZZER status. Press ENTER to confirm.
button to scroll to the alarm duration. You can choose from 15, 30, 45 and 60
/ to select YES and press ENTER to
- EN 6 -
/ to select "YES/NO"