THOMSON MIC200IBT Manual Del Usuario página 21

Snooze
1. Whenever the alarm comes on, it can be temporarily suspended for a short period of approximately
9 minutes, by pressing the "SNOOZE" key once.
2. The alarm will then automatically come on again after approximately 9 minutes.
3. To deactivate the snooze, press and release the "POWER" key once.
Sleep Timer
1. Repeatedly press the SLEEP button; you can set 90/80/70/60/50/40/30/20/10 minutes. This is
useful for falling asleep to music at night.
2. If you want to cancel the sleep mode, repeatedly press SLEEP to select OFF; the sleep mode will
cancel.
FM Radio
Carefully extend the telescopic aerial to its full length. You can program a maximum of 20 preset radio
stations (FM)
Auto Scan
1. Press the SOURCE key to select "RADIO" mode.
2. Long press the
station of sufficient signal strength (30 stations preset).
3. After a few seconds, the display will update. The display will show the station frequency.
4. Press MEM to view the preset radio stations.
5. Press MEM+ or MEM- to listen to the radio.
6. To find other stations, press and hold the
7. To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
Manual Scan
1. Press the SOURCE key on the main unit to select "RADIO'' mode.
2. Press or
frequency up or down by 100 kHz.
3. Once you find a station you want to save, press the MEM button on the remote control. "P01"
will be shown on the display; press MEM+/MEM-until the desired memory position number
appears on the display. Press the MEM again to confirm and save the current station.
4. Press MEM+ or MEM- to view or listen to the radio station.
(Note: When the waveband end is reached, the radio will recommence tuning from the opposite
waveband end. If no stations are found, please ensure the aerial is extended and test the reception by
doing another auto scan in a different location.)
Bluetooth Mode
You must follow several steps to connect your mobile phone:
1. Activate Bluetooth from your mobile phone (please refer to your phone's user manual)
2. Press the POWER button to turn on the unit, then press the SOURCE button repeatedly until the
"Bluetooth" indicator appears on the LCD display. It will be ready to pair automatically.
3. Use your mobile phone to search for the Bluetooth device named "MIC200IBT"/"MIC201BT"/
MIC205IBT".
4. Your mobile phone will find "MIC200IBT"/"MIC201BT"/"MIC205BT" and will present the option to
connect or not. Please connect to it using the password "0000" (if any). When you are successfully
connected, the Bluetooth indicator "Bluetooth connected" appears on the LCD display.
Automatically Connecting with Your Phone
Pairing is only needed the first time the unit and phone are used together. When the unit and phone
have been paired once, they will automatically connect when the unit is on and Bluetooth is activated
button, and your radio will scan and stop automatically when it finds a
to tune to a station. Each press on the tuning button will change the
- EN 7 -
button as before.