Descargar Imprimir esta página

Tectro TS126 Instrucciones De Uso página 108

Ocultar thumbs Ver también para TS126:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

E
OPERATION WITH REMOTE CONTROL
NOTE!
• Always aim the remote controller towards the receiver on the indoor unit and make sure there
are no obstacles in between the remote control and the receiver on the indoor unit. Otherwise
the remote control signal will not be picked up by the receiver and the air conditioner will not
work properly.
• The maximum distance at which the remote control will work is approximately 6 to 7 meters.
Introduction of Function Buttons on the Remote Controller
On/off Button: Push this button to start the unit operation. Push the button again to stop the unit
operation.
Mode Button: Each time you press the button, a mode is selected in a sequence that goes from AUTO
COOL DRY HEAT and FAN only as the following figure indicates:
AUTO
Button: Push the button to increase the indoor temperature setting to 30ºC.
Button: Push the button to decrease the indoor temperature setting to 17ºC.
Fan Button: This button is used for selecting Fan Speed. Each time you press the button, a fan speed
is selected in a sequence that goes from AUTO, LOW, MED to HIGH, then back to Auto. When you select
the AUTO or DRY mode, the fan speed will be automatically controlled and you can not set the fan
speed.
SLEEP Button: Press this button to go into the Energy-Saving operation mode. Press it again to cancel.
This function is only can be used on COOL, HEAT and AUTO mode and maintain the most comfortable
temperature for you.
NOTE: While the unit is running under SLEEP operation mode, it would be cancelled if you press the
other button.
Swing Button: Press the SWING button to activate the swing feature. Push the button again to stop.
Air direction Button: Press this button to change the swing angle of the louver. The swing angle of
the louver is 6
o
C for each press. When the louver swing at a certain angle which would affect the coo-
ling and heating effect of the air conditioner, it would automatically change the swing direction . No
symbol will appear in the display area when press this button.
4
108
fig. 1
COOL
DRY
HEAT
FAN

Publicidad

loading

Este manual también es adecuado para:

Ts133