Publicidad
Idiomas disponibles
Idiomas disponibles
Self-cleaning Oven With Catalytic
Special self-cleaning panels covered in a micro-porous coating are
available as optional extras for all models. If they are fitted, the oven
no longer needs to be cleaned by hand.
The fat that is splattered onto the sides of the oven during roasting is
eliminated by the microporous coating which breaks the fat down by
catalysis and transforms it into gas.
Excessive splattering may nevertheless block the pores and therefore
hinder self-cleaning. The self-cleaning capacity may be restored by
switching on the empty oven to maximum for about 10-20 minutes.
Do not use abrasive products, metal cleaning wads, sharp objects,
rough cloths, or chemical products and detergents that may
permanently damage the catalytic lining.
It is a good idea to use deep roasting trays to roast fatty foods such as
joints of meat etc. and to put a tray underneath the grill to catch surplus
fat.If the walls of the oven are so thickly coated in grease that the
catalytic lining is no longer effective remove surplus grease with a soft
cloth or sponge soaked in hot water.
The lining must be porous for self-cleaning to be effective.
N.B.: All catalytic linings currently on the market have a working life of
about 300 hours. They should therefore be replaced after about 300
hours.
OVEN LIGHTING
Disconnect the power supply from the oven before cleaning or
replacing the lamp.
The bulb and its cover are made of material resistant to high
temperatures.
Bulb characteristics:
230 V AC - 25W- E 14 base Temperature 300°C to change a defective
bulb, just :
•Unscrew the glass cover,
•Unscrew the bulb,
•Replace it with the same type: see characteristics above,
•After replacing the defective bulb, screw back the
protective glass cover.
CLEANING THE DOOR GLASS
Internal door glass of this oven can be removed and cleaned.
In order to clean the internal glass follow these instructions;
• Open the door of the oven.
(Picture1)
Picture 2
• Remove the screws as shown in
Picture (Picture 3)
Picture 4
• Remove the glass by gently pulling it
out of the door frame (Picture 5)
1
2
3
Picture 6
•
After cleaning the glass re-
assemble the parts in the
reverse order of removal.
• ON ALL GLASES LOW-E
sign must be properly
readable and must be
positioned on the left corner of
the door, close to the left side
hinge. In this way the printed
st
surface of the 1 glass will
remain INSIDE the door.
EN 06
• Lock the hinges as shown in Picture
2 before starting the cleaning
operation.
Unlock the hinges when the cleaning
operation is finished. (Picture 2)
Picture 3
• Remove the top metallic cover by
pulling it upwards. (Picture 4
• *For Pyrolytic ovens, please
nd
rd
remove also 2 and 3 glasses .
(
Picture 6)
Picture 7
Picture 1
Picture 5
Publicidad
