Publicidad
Idiomas disponibles
Idiomas disponibles
9. PLACING THE GREASE BUCKET
Parts Required:
1
x
Grease Bucket (#15)
Installation:
•
Place the grease bucket on the spout hook on the underside of the
main barrel. Ensure it is level to avoid grease spills.
IMPORTANT: Remove grease bucket prior to moving unit to avoid spills.
10. CONNECTING TO A POWER SOURCE
•
STANDARD OUTLET
This unit requires 110 volt, 60hz, 375w, 5 amp service. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off. The control uses
a 5 amp, 120 volt, fast-blow fuse to protect the board from the igniter.
GFCI OUTLETS
•
This unit works on most GFCI outlets, with a recommended size of
15 amp service. If the GFCI outlet is highly sensitive to power surges,
it will likely trip during the start-up phase of operation. During the
start-up phase, the igniter draws 300-700 watts of electricity which
can be too much power for a GFCI outlet to handle. Each time the GFCI
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
•
ON THE ROAD
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. The unit can operate using a 12 volt, 100 watt
POSITIVE WAVE LENGTH inverter plugged into your automobile outlet.
To use the automatic igniter, it is recommended to use a minimum of a
1000 watt POSITIVE WAVE LENGTH inverter.
IMPORTANT: Disconnect unit from power source when not in use.
9
10
FAST-BLOW FUSE,
5 AMP
11
Publicidad
