Publicidad
Idiomas disponibles
Idiomas disponibles
troubleshooting
CHECK THESE POINTS IF YOUR DISHWASHER...
PROBLEM
POSSIBLE CAUSE
The door is not closed completely.
No cycle is selected.
The power cable is not connected. Connect the power cable properly.
Will not start.
The Control Panel is locked.
A circuit breaker is open.
Cold water is being supplied.
Is taking too long
with an operation or
cycle.
You selected an inappropriate
cycle.
The water temperature is low.
Low water pressure.
The water is too hard.
Dishwasher detergent was not
used.
Remains food
Detergent remains in the
particles on dishes.
dispenser.
(Not cleaning
properly.)
There is no rinse aid.
A nozzle is clogged.
The dishes are improperly loaded.
Too many dishes have been
loaded.
SOLUTION
Check if the door is latched and closed
completely.
Select a proper cycle.
Unlock the child lock
Reset the circuit breaker.
Make sure the Water supply line is
to a hot water supply
(Additional time is required to heat cold
water.)
Select a cycle according to the number and
soil level of the dishes, as directed in this
manual.
Connect the water supply line to a hot
water supply.
For best performance, the temperature of
the supplied water should be 120
The water pressure should be between 20
and 120 psi (140 - 830 kPa).
Use high-quality, fresh detergent with rinse
aid.
Use automatic dishwasher detergent.
We recommend a powder or gel type
dishwasher detergent.
Make sure large items such as cookie
sheets, cutting boards, or contaners, etc.
are not blocking the detergent dispenser
and preventing it from opening properly.
Rearrange the dishes so they do not
interfere with detergent dispenser
operation.
Check the dispenser and add rinse aid.
Use liquid type rinse aid.
Clean the nozzle
Rearrange the dishes so they do not
interfere with nozzle rotation and detergent
dispenser operation.
Load only an appropriate number of dishes.
Load your dishes as recommended. (See
page 14.)
English - 23
connected
.
°F
(49
°C
).
. S
ee page 20.
Publicidad
