Publicidad
Idiomas disponibles
Idiomas disponibles
Operating
Listening to music of the iPod
You can listen to music of the iPod (see page 4 for compatible iPod
models) on the headset.
1
Press and hold the POWER button on the headset for about 2
seconds.
The headset indicator (blue) and headset indicator (red) flash
together twice and the headset is turned on.
2
Connect the transmitter to the iPod then turn on the iPod and
start playback on the iPod.
The transmitter indicator status will vary as follows, and the
Bluetooth connection between the transmitter and the headset is
established.
Transmitter indicator flashes twice: Power is on
Transmitter indicator flashes (at about 1-second intervals):
Connecting in process
Transmitter indicator flashes twice slowly (at about 5-second
intervals): Connected (Playback will start automatically)
If the Bluetooth connection is not established within 5 minutes*,
the transmitter automatically turns itself off. In this case, turn
it on again by pressing and holding the power button on the
transmitter for about 1 second.
* iPod backlight may turn on in this 5 minutes.
Notes
•
If the Bluetooth connection cannot be established with the headset paired
already, try pairing again (page 27).
•
If playback cannot start automatically, try start playback on iPod.
•
If you press and hold the power button on the transmitter for about 1
second, the transmitter will connect to the iPod and start playback
automatically.
•
Even if you control the volume on the iPod, sound from the headset will not
change.
1
1
US
US
Publicidad
