Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Advanced operation
Pairing with other Bluetooth devices
What is pairing?
Bluetooth devices need to be "paired" with each other beforehand.
Once Bluetooth devices are paired, there is no need for pairing again,
except in the following cases:
• Pairing information is deleted after repair, etc.
• This product is paired with 9 or more receiving devices.
This product can be paired with up to 8 Bluetooth device respectively.
If a new device is paired after 8 devices have been paired, the device
whose latest connection time is the oldest among the 8 paired devices
is replaced by the new one.
• This product is initialized.
All pairing information is deleted (page 38).
Pairing transmitter with other Bluetooth receiving devices
1
Turn on the power of iPod.
(Make sure the iPod is in pause mode.)
2
Connect the transmitter to the iPod (page 16).
3
Place the transmitter and the Bluetooth receiving device to be
paired together within 1 m (3 ft).
4
Set the Bluetooth receiving device to enter "Pairing in process."
See the operating instructions supplied with the Bluetooth
receiving device.
Notes
•
Passcode* of the transmitter is fixed at "0000," "1234," or "8888."
Depending on the Bluetooth receiving device, it may be necessary to input
the passcode (in this case, "0000," "1234," or "8888"). The transmitter
cannot be paired with a Bluetooth receiving device whose passcode is not
"0000," "1234," or "8888."
•
If the Bluetooth receiving device requires a passcode, input "0000."
* Passcode may be called "Passkey," "PIN code," "PIN number," or
"Password."
Continued
1
1
US
US
Publicidad
Capítulos
Tabla de contenido
