Publicidad
Idiomas disponibles
Idiomas disponibles
English
(2) REMOVE ALL STAPLES FROM STAPLER.
DO NOT push or rest Push Lever against any surface.
DO NOT FORCE OR USE TOOLS TO OPERATE
SWITCH.
Set the switching device to the upward position
(to set to SINGLE SEQUENTIAL ACTUATION
MECHANISM).
(Set the switching device to the upward position
completely as shown in the diagram. Otherwise, it will
not operate properly.)
(3) Adjust the air pressure to 70 psi (4.9 bar 5 kgf/cm2).
Connect the air hose.
□ THE STAPLER MUST NOT LEAK AIR.
(4) Remove the fi nger from the trigger and press the
push lever against the workpiece.
□ THE STAPLER MUST NOT OPERATE.
Depress push lever
(5) Separate the push lever from the workpiece.
Next, point the stapler downward, pull the trigger and
then wait in that position for 5 seconds or longer.
□ THE STAPLER MUST NOT OPERATE.
12
Upward position
Switching device
Do not pull trigger
(6) First pull the Trigger.
Next, depress the Push Lever against the wood.
□ THE STAPLER MUST NOT OPERATE.
(7) 1 Without touching the trigger, depress the push
lever against the workpiece.
Next, pull the trigger.
□ THE STAPLER MUST OPERATE.
If the screw is left, skip (8)
through (10) and proceed from
(11).
→ If the screw is attached, the unit can be
operated in SINGLE SEQUENTIAL ACTUATION
MECHANISM.
(8) Disconnect the air hose.
REMOVE ALL STAPLES FROM STAPLER.
Remove the hook if it is attached.
→ When the hook is attached, do not operate with
CONTACT ACTUATION MECHANISM.
DO NOT push or rest Push Lever against any surface.
DO NOT FORCE OR USE ANY TOOLS TO
OPERATE SWITCH.
Set the switching device to the downward position
(CONTACT ACTUATION MECHANISM).
(Set the switching device to the downward position
completely as shown in the diagram. Otherwise, it will
not operate properly.)
Pull trigger
Screw
Downward position
Switching device
Publicidad
