English
NOTE:
The information contained in this Manual is designed to assist you in the safe maintenance of the Stapler.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Stapler.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 3 – 7).
● Disconnect air hose and remove all staples
from Stapler when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed staple in the following order:
1 DISCONNECT AIR HOSE.
2 Remove all staples.
3 Release the lock lever and open guide plate.
3
Lock lever
3
Guide plate
4 Remove the jammed staple with a slotted-head
screwdriver.
Guide plate
5 Close guide plate and latch.
6 In case of frequent jam, contact a metabo HPT
authorized service center.
2. Storing
○ When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
20
MAINTENANCE
WARNING
1
Disconnect
air hose
○ Do not store the Stapler in a cold weather
environment.
Keep the Stapler in a warm area.
○ When not in use, the Stapler should be stored in a
warm and dry place.
Keep out of reach of children.
3. WARNING LABEL
Do not use the Stapler with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
4. Maintenance chart (See page 21)
5. Operator troubleshooting (See page 21)
CAUTION
● In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
SERVICE AND REPAIRS
● Only
service
metabo HPT, distributor or employer
shall repair the Stapler.
● Use only parts supplied or recommended by
metabo HPT for repair.
All quality Staplers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE:
Specifi cations are subject to change without any
obligation on the part of metabo HPT.
Warning label
WARNING
personnel
trained
by