Publicidad
Idiomas disponibles
Idiomas disponibles
English
Push lever
● A staple will fi re each time the trigger
is depressed as long as the push lever
remains depressed.
(2) Continuous operation (Push lever fi re)
Using CONTACT ACTUATION MECHANISM
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Do not press the stapler against the
workpiece with excessive force.
2) Separate the stapler from the workpiece
as it recoils after stapling.
● If the hook is affi xed, do not operate with
CONTACT ACTUATION MECHANISM.
1 Follow the steps below to set up the CONTACT
ACTUATION MECHANISM (as shown in the
diagrams that follow).
● Disconnect the air hose and remove all
staples.
● Do not depress the push lever.
● Do not apply any unnecessary pressure or
use any tools to move the switch.
1) Remove the screw if it is still attached.
See "How to Remove the screw" in the
"METHODS OF OPERATION".
2) Set the switching device to the downward
position (to set to CONTACT ACTUATION
MECHANISM).
(Set the switching device to the downward
position completely as shown in the diagram.
Otherwise, it will not operate properly.)
16
3
4
Trigger
WARNING
WARNING
WARNING
2 Pull the trigger with the Stapler off the workpiece.
3 Depress the push lever against the workpiece to
drive a staple.
4 Move the Stapler along the workpiece with a
bouncing motion.
Each depression of the push lever will drive a
staple.
As soon as the desired number of staples have been
driven, remove fi nger from the trigger.
Switching device
4
Push lever
Previously pull the trigger
● Keep your fi nger off the trigger except during
fastening operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This metabo HPT Stapler
may bounce from the recoil of driving a
fastener and unwanted subsequent fastener
may be driven, possibly causing injury.
● Some types of loaded staples can spark
out of the muzzle during a staple driving
operation. Exercise caution!
The SINGLE SEQUENTIAL ACTUATION MECHANISM
is for use where precision fastener placement is desired.
1 Downward position
2
WARNING
Publicidad
