Descargar Imprimir esta página

Orbegozo AIR 41 Manual De Instrucciones página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

AIR 41
3. Humidification button: press the "COOL" button to make it start to work. If you add the cold packs, the
temperature of the air outlet vent can drop up to 3ºC below the ambient temperature after a few minutes. If
you press the button again, this function stops.
4. Off button: if you are not going to use the appliance, press the "0" button.
THE USE OF ICE BOX
The ice crystal has a particular feature of keeping cool; it can absorb heat from water and let the water
temperature in the water tank below environmental temperature, so the air will be much cooler.
Using methods:
a) Turn the flange and remove the water tank. Add water to the ICE BOX under not full situation and put it
into the refrigerating chamber of refrigerator to make sure that it icing absolutely.
b) Ice crystal put the ICE BOX in the water tank.
c) There have two ICE BOX, can use circularly. Place the water tank and turn the flange to fix the water tank
in its place.
CLEANING AND MANTENANCE
1. Clean the air filter screen
Unplug the power plug, push the flanges of the air filter screen up, remove it from appliance. Clean the air
filter screen with neutral detergent and banister brush. Then clean it with clear water and reinstall to
appliance.
2. Clean the wetted pad
Unplug the power plug, take down the air filter screen, then draw the wetted pad from support. Clean the
wetted pad with neutral detergent and banister brush. Then clean it with clear water and reinstall to the
appliance.
Attention: the wetted pad must be installed flatly, in order to avoid leaking.
3. Clean the water tank
Unplug the power plug, turn the flange and draw out 1/2 the tank. To remove completely, turn the two
flanges which hold the water pump, and you can remove totally. Clean it with neutral detergent and rinse
with water. Once dry, place it again, putting the water pump as it was.
Note: if you need to clean the tank completely, you should unscrew the screw under the base, also should
unscrew the screw of water pump inside the tank.
4. Clean the shell
Clean with neutral detergent and soft cloth.
Attention: unplug the power plug when clean the appliance, since there have high pressure in the body. Do
not leave any water on the control panel.
Attention: Must unplug the power plug when cleaning. Don't make the water into the control panel.
11

Publicidad

loading