Publicidad
Idiomas disponibles
Idiomas disponibles
To override all sensor functions, set the Ultrasonic Sensitivity trimpot to the fully counterclockwise (Service) position.
This bypasses the occupancy control functions of the sensor, but still allows the lights to be manually controlled with a light switch, if one
is installed. While in Service mode, the red LED will turn on and remain on to confirm the unit is in Service mode status.
Catalog #
Description
DT-300
Dual Technology Occupancy Sensor, 360° Low Voltage
w/Isolated Relay and light level sensor
DT-305
Dual Technology Occupancy Sensor, 360° Low Voltage
BZ-50, BZ-150
Power Pack: 120/277VAC, 50/60Hz, 225mA, 20A ballast or incandescent, 1HP@120/250VAC
BZ-200, BZ-250
Power Pack: 120/277 VAC, 50/60Hz, 225mA, 20A ballast/ELV/MLV/incandescent/LED;16A E-ballast/CFL
S120/277/347E-P
Auxiliary Relay Pack: 120/277VAC, 60Hz, 20A Ballast, 347VAC, 60Hz, 15A Ballast
All sensors are white.
BZ series power packs supply power for up to 5 DT-300 sensors.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own expense.
SERVICE
ORDERING INFORMATION
7
Publicidad
