General Operations; Adjusting The Sound Characteristics - Blaupunkt RPD 545 Manual De Instrucciones

General Operations

Power On/Off
Turning on the power
Press the to turn on the unit.
PWR
Turning off the power
Press the for more than 2 seconds.
PWR
Setting the Clock
The clock uses a 12-hour display system.
1.
Turn the ignition key to the ON position.
2.
Press the to turn on the unit.
PWR
3.
Press the and hold 2 seconds to start.
DISP
Use the following buttons to set the clock. (The blinking
section can be adjusted.)
/ : Adjust the Hour and minute
: To activate Hour blink
: To activate Minute blink
4.
Press the to activate the clock.
DISP
Ignition-off Clock Call
The display will illuminate showing the time and then automati-
cally shut off after 5 seconds.
Briefly press the while the ignition switch is in the " OFF "
DISP
position to activate.
Display Selector
Each time the is pressed, the display window will change
DISP
as shown below;
• Radio mode
Frequency and Clock.
• CD mode
Elapsed track time and clock.
Volume Level Control
Press the to adjust the volume level.
/
VOL
: Volume up
: Volume down.
You can check the volume level visually with the indicators in
the display window.
Volume level meter
Muting the Sound
Briefly press while the receiver is on.
PWR
While muting the sound, the MUTE indicator
is blinking.
To restore the previous volume level, press
Loudness Effect
When listening to music at low volume levels, this feature will
boost the extremes of the bass and treble ranges to compen-
sate for the negative characteristics of human hearing.
Press the .
LD/SENS
The "LD" indicator appears in the display window.
Pressing this button again will cancel this feature.

Adjusting the Sound Characteristics

1.
Press the
AUD
BASS TREBLE
2.
Press the following buttons to adjust the selected item. Make
the adjustment within 5 seconds after selecting. After 5
seconds, the display window will revert to previous indica-
tion.
BASS
TREBLE
BALANCE
FADER
MUTE LEVEL
on the display
You can check the each level visually with the indicators in the
display window.
again.
PWR
to select the desired adjustment mode.
BALANCE & FADER Mute level
Adjustment Range
/ BASS -7 BASS 7 /
/ TREB -7 TREB 7 /
L
9 (Full left) 9 (Full right)
R
R
9 (Full front) 9 (Full rear)
F
(-80) (-0)
Center level mark
FADER
BALANCE
E-3