How to reinstall the door
You can replace the upper door the same way you replace the full door.
1.
Firmly grasp both sides of the door at the top.
2.
With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the
hinge arm must be fully inserted into the bottom of the slot.
Hinge
Hinge
arm
arm
Bottom
Bottom
edge of
edge of
slot
slot
Indentation
Indentation
3.
Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4.
Push the hinge locks up against the front frame of the oven cavity into the
locked position.
5.
Close the oven door.
Hinge lock
Hinge lock
Unlocked position
Unlocked position
Locked position
Locked position
Removing and reinstalling the storage drawer
1.
Slide open the drawer until it stops.
2.
Locate the roller guide clips on either
side. Using both hands, pull down the
left clip while lifting the right clip, and
then remove the drawer.
3.
Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
4.
Put the drawer in the roller guides on
either side, and then snap the clips into
place.
English 65