Hilti TE 60-ATC Manual De Instrucciones página 11

CAUTION Check that the clamping band is en-
5.
gaged in the groove provided on the power tool.
Secure the side handle by turning the grip clockwise.
6.2 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning
en
the handle counterclockwise.
2. Push the depth gauge into the two guide holes in
the side handle clamp.
7 Operation
CAUTION
In accordance with the applications for which it is de-
signed, the power tool produces a high torque. Always
use the side handle and hold the power tool with both
hands. The user must be prepared for sudden sticking
and stalling of the insert tool.
CAUTION
Always check to ensure that the selector switch is set
to the correct function.
CAUTION
Use clamps or a vice to hold the workpiece securely.
CAUTION
Check the insert tool for damage or uneven wear each
time before use.
7.1 Preparing for use
CAUTION
Wear protective gloves when changing insert tools as
the insert tools get hot during use.
7.1.1 Adjusting the depth gauge
1. Release the screw at the depth gauge.
2. Adjust the depth gauge to the desired drilling depth.
3. Tighten the screw at the depth gauge firmly.
7.1.2 Fitting the insert tool 3
1. Disconnect the supply cord plug from the power
outlet.
2. Check that the connection end of the insert tool is
clean and lightly greased. Clean it and grease it if
necessary.
3. Check that the sealing lip of the dust shield is
clean and in good condition. Clean the dust shield
if necessary or have it replaced if the sealing lip is
damaged.
8
3. Tighten the side handle securely by turning the
grip section. This also clamps the depth gauge in
position.
6.3 Unlocking the power tool
Please refer to the section "Operation / TPS theft protec-
tion system (ATC)".
6.4 Use of extension cords and generators or
transformers
See section "Description / use of extension cords".
4. Push the insert tool into the chuck and rotate it while
applying slight pressure until it engages in the guide
grooves.
5. Push the insert tool further into the chuck until it is
heard to engage.
6. Check that the insert tool has engaged correctly by
pulling it.
7.1.3 Removing the insert tool 4
1. Disconnect the supply cord plug from the power
outlet.
2. Open the chuck by pulling back the insert tool lock-
ing sleeve.
3. Pull the insert tool out of the chuck.
7.2 Operation
CAUTION
Working on the material may cause it to splinter. Wear
eye protection and protective gloves. Wear breathing
protection if no dust removal system is used. Splin-
tering material presents a risk of injury to the eyes and
body.
CAUTION
The work generates noise. Wear ear protectors. Expo-
sure to noise can cause hearing loss.
CAUTION
Improve the blood circulation in your fingers by re-
laxing your hands and exercising your fingers during
breaks between working.
7.2.1 TPS theft protection system (ATC)
NOTE
The ATC version of the tool can be equipped with the
optional theft protection system. If the power tool is
equipped with this feature, it can be unlocked and made