Publicidad
Idiomas disponibles
Idiomas disponibles
English
SPECIFICATIONS
Motor
Power Source
Current
Capacity
No-Load Speed
Full-load Blow
Weight
APPLICATIONS
Rotation and hammering function
○
Drilling anchor holes
○
Drilling holes in concrete
Hammering only function
○
Crushing concrete, chipping, digging, and squaring
(Some applications need optional accessories)
PRIOR TO OPERATION
1.
Power source
Ensure that the power source to be utilized conforms
to the power source requirements specifi ed on the
product nameplate.
2.
Power switch
Ensure that the switch is in the OFF position. If the
plug is connected to a receptacle while the switch is
in the ON position, the power tool will start operating
immediately and can cause serious injury.
3.
Extension cord
When the work area is far away from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short
as practicable.
WARNING
Damaged cord must be replaced
or repaired.
4.
Check the receptacle
If the receptacle only loosely accepts the plug, the
receptacle must be repaired. Contact a licensed
electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause
overheating, resulting in a serious hazard.
5.
Confi rming condition of the environment:
Confi rm that the work site is placed under appropriate
conditions conforming to prescribed precautions.
6
ASSEMBLY AND OPERATION
Single-Phase, Series Commutator Motor.
Single-Phase, 120 V 60 Hz
10.0 A
Drill Bit: 1-9/16" (40 mm)
Core Bit: 4-1/8" (105 mm)
620 /min
2,800 /min
15.6 lbs (7.1 kg)
6.
How to install dust cover (Fig. 2)
Always install the dust cover on the drill bit or the taper
shank adaptor. Insert the dust cover until it lies fl ush
in the groove.
NOTE
For a thick drill bit, insert the dust cover from drill rear.
Dust cover
7.
How to install tool
CAUTION
For tools such as a drill bit and a bull point, use
only metabo HPT genuine parts.
(1) Clean, then smear the tool shank with the grease or
oil.
(2) Pull the tool holder in the direction of arrow
rotate it in the direction of arrow
Fully insert the tool shank into the hexagonal hole of
the front cover. (Fig. 3)
Tool
Grease
Front Cover
Tool Holder
Tool shank
Insert up to the groove
Fig. 2
(counterclockwise).
Fig. 3
and
Publicidad
