EINHELL TE-DH 32 Manual De Instrucciones página 16

6. Operation
Important.
To avoid danger, the machine must only be
held using the two handles (1/3). Otherwise
you may suff er an electric shock if you chisel into
cables.
6.1 Switching On and Off (Fig. 6)
Switching on:
Press the On/Off switch (6)
Continuous operation:
Secure the On/Off switch (6) with the On/Off
switch lock (5).
Switching off :
Press the On/Off switch (6) briefl y or let go.
6.2 Practical tips
6.2.1 Sharpening chisel tools
You will only achieve good results if you use sharp
chisels. You should therefore sharpen the chisels
promptly to ensure that they produce good results
and provide a long service life.
Notice!
You only require slight contact pressure for chi-
seling. Excessive contact pressure will place an
unnecessary strain on the motor. Check the chi-
sels at regular intervals. Sharpen or replace blunt
chisels.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_TE_DH_32_SPK9.indb 16 Anl_TE_DH_32_SPK9.indb 16
GB
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering spare parts
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
- 16 -
12.02.2020 15:49:45 12.02.2020 15:49:45